Drill pilot holes that stop splitting
-
Match the bit to the screw core.
Hold the bit in front of the screw: it should hide the shaft but leave the threads visible.
-
Mark and dimple the spot.
A nail tap or awl press stops the bit wandering on the first turn.
-
Drill straight, full depth.
As deep as the screw is long. Tape on the bit marks the stop.
-
Countersink for a flush finish.
A quick chamfer lets the screw head sit level instead of crushing the surface.
-
Drive by hand at the end.
Power to near-flush, hand tool for the last turn. That is what prevents stripping.
- 1 Founder draft core @bernard ⚡ new
#1 becomes the Core. This atoma is young: submit a better distillation and take the seat.
No gear needed. Your pot, a timer and ice are enough. That is the point.




