ato.ma
atom · diy / plumbing

Seal a bathtub with clean silicone

draft · verifying asked 185 ways distilled today
  1. 1

    Remove every trace of the old seal.

    Scrape it out, then a solvent remover. New silicone will not bond to old silicone.

  2. 2

    Dry the joint completely.

    Twenty-four hours if it was wet behind. Trapped moisture is what breeds the black mould.

  3. 3

    Fill the bath with water first.

    The tub drops under load. Sealing empty means the joint tears the first time you bathe.

  4. 4

    Lay one continuous bead.

    Cut the nozzle at 45 degrees, move steadily, never stop mid-run.

  5. 5

    Tool it once and leave it.

    A wet finger or tool in one pass. Going back over it is what ruins the finish.

0 of 5 done
  • 1 Founder draft core @bernard ⚡ new

#1 becomes the Core. This atoma is young: submit a better distillation and take the seat.

No gear needed. Your pot, a timer and ice are enough. That is the point.

Founder draft
@bernard · challengers welcome
fanouts · the community votes where this atom ends
people ask · parameters live here, knowledge links out
complexes
related atomas · same pillar
the neighborhood · nearest by search-similarity
also asked as

how to seal a bathtub · silicone sealant bath · recaulk bathtub · bathroom sealant application · replace bath silicone +185 phrasings, one home

The best media for this problem, one per channel

Best of YouTube How to Seal a Bath (2 Minute Guide!) | Victorian Plumbing Victorian Plumbing · chapters pending alignment

nearby atomas